CHIEF LSA1U Installationsanleitung Seite 6

LSA1U/MSP-DCCLSA1U/MSP-DCCLSA2
INSTALLATION
The LSA1U / MSP-DCCLSA1U / MSP-DCCLSA2 mount is
designed to be mounted to a bare 8" concrete, 8"x8"x16"
concrete block, or 2" x 4" wood studs (16" or 24" on center) wall
covered by drywall with 5/8" maximum thickness.
Locate Mounting Site
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! It is the installers responsibility
to make certain the structure to which the mount is being
attached is capable of supporting five times the combined
weight of all components located on the mount, not to exceed
200 lbs (90.7 kg).
NOTE:
Proceed to either the Installing to a Wood Stud Wall
section or the Installing to a Concrete Wall section.
Installing to a Wood Stud Wall
1. Determine the center of the TV screen, and where it should
be located on the wall.
2. Locate the closest stud to the left and right of the selected
location.
NOTE:
If the screen area lies over a stud, use that stud and the
stud to either the left or right of it.
3. Line up the diamond shapes on mount (V) with center of
screen marking to determine vertical center. (See Figure 1)
4. Measure up 7" (177.8mm) from the center point to mark
location of the upper mounting slots. (See Figure 1)
Center of screen
Figure 1
5. Using a level, mark the wall on each stud to attach the
mount through the upper mounting slots. (See Figure 2)
6. Drill one 7/32" (5.5mm) pilot hole in each stud.
6
7"
(177.8mm)
(V)
Vertical center
of mount
7. Partially install two 5/16 x 2-1/2" flanged lag bolts (N) into
pilot holes but do not tighten to wall.
8. Hang mount (V), aligning upper mounting slots over lag
bolts and adjust side-to-side for proper location.
9. Place one slotted washer (Q) over each flanged lag bolt.
(See Figure 2)
10. Tighten lag bolts to secure mount (V) to wall at upper
mounting slots.
7
9 (Q) x 2
10
(V)
(Q) x 2
13
(N) x 2
13
Figure 2
11. Mark the attachment points for the lower mounting slots,
making sure the attachment points are located on the studs.
(See Figure 2)
12. Drill 7/32" (5.5mm) pilot holes at markings for lower
mounting holes. (See Figure 2)
13. Use two 5/16 x 2-1/2" flanged lag bolts (N) and two 5/16"
slotted washers (Q) to attach the mount to the wall through
the lower mounting holes. (See Figure 2)
14. Slide rails to approximate center of screen location.
15. Proceed to Attaching Interface Brackets to Screen
section.
Installing to a Concrete Wall
1. Determine the center of the TV screen, and where it should
be located on the wall.
2. Line up the diamond shapes on mount (V) with center of
screen marking to determine vertical center. (See Figure 1)
Installation Instructions
(N) x 2
6
5
11 12