Konig & Meyer 24120 Bedienungsanleitung Seite 7

USER NOTES / FUNCTION
SAFETY NOTES
- WALL & FASTENING MATERIAL: Both must be suitable to carry the loads permanently;
- WALL & FASTENING MATERIAL:
- WALL & FASTENING MATERIAL:
- MATERIAL OF SPEAKERS: Both the housing and the plug-on socket must have the
- MATERIAL OF SPEAKERS:
- WALL MOUNT: First check that the bracket is in proper condition - e.g. correct installed support bracket b -
- WALL MOUNT: then mount loudspeaker
- APPLIANCE: Use appropriate installation equipment: e.g. safe ladders or similar.
- PERSONNEL: Use sufficient personnel for assembly, disassembly and tilt adjustment of the loudspeaker
- PERSONNEL: (best would be 2 persons that are professionally and physically suited).
5.& 6. SETTINGS
5. INCLINATION
NOTE:
Before adjusting the inclination, take off the loudspeaker
if necessary or get help from another person, who reliably
holds the loudspeaker during the entire adjustment
5.1 Loosen screw connection between
5.1 support tube and support bracket
5.1 and pull the parts out of the borehole
5.2 Screw the support bracket to the
5.2 adjustable tube at the desired position
5.2 - The arm can be positioned at eleven inclination
5.2 angles from 0° (horizontal range) to -22°
5.2 (see chapter 7. DIMENSIONS)
6. DIRECTION
6.1 Slightly loosen the screw connection between
6.1 the support tube and the wall bracket - do not unscrew.
6.2 Swivel arm in desired direction.
6.2 Then retighten the screws and press on the protective caps.
7. DIMENSIONS
the proper assembly of the goods must also be observed.
Use all six mounting holes.
appropriate size (ø35/36 mm) and quality