Initial Use; Unpacking; Accessories; Before Use - FLORABEST HTA FKTSA 40-Li A1 Bedienungs- Und Sicherheitshinweise

This charger is only designed
¢
for charging the battery pack
type: FAP 40 A1.
CAUTION! RISK OF EXPLOSION
Never charge non-rechargeable
45
batteries! Protect the battery pack
45
against heat, e. g., against continuous
intense sunlight, fire, water and
moisture. Danger of explosion.

Initial use

Q

Unpacking

Q
WARNING!
The product and the packaging are not
u
children's toys! Children must not play with
plastic bags, sheets and small parts! There is
a danger of choking and suffocation!
1. Unpack all parts and lay them on a flat, stable
surface.
2. Remove all packing materials and shipping
devices if applicable.
3. Make sure the delivery contents are complete
and free of any damage. If you find that
parts are missing or show damage do not
use the product but contact your dealer. Do
not use the product unless missing parts have
been delivered in addition or defective parts
have been replaced. Using an incomplete
or damaged product represents a hazard to
people and property.
4. Ensure that you have all the accessories and
tools needed for assembly and operation.
This also includes suitable personal protective
equipment.

Accessories

Q
To operate this product safely and correctly, the
following accessories, i. e. tools and attachments,
are necessary:
Suitable personal protective equipment
o
Oil suction gun with pinpoint tip
o
Sharpening set (chain file)
o
Ensure that you have the accessories and tools
needed for commissioning and operation available.
This also includes suitable personal protective
equipment.
Accessories and tools are available through your
authorised dealer. When buying always consider
the technical requirements of this product (see
"Technical data").
If you are not certain, ask a qualified specialist and
get advice from your trusted dealer.
NOTE
This instruction manual contains information
u
and suggestions for several attachments and
their uses. The attachments depicted are not
necessarily included in the shipment, but are
meant to indicate additional possibilities for
using this product.

Before use

Q
Attaching / removing the
Q
battery pack
Attaching the battery pack:
1. Align the battery pack
pack bay and slide it into it. Ensure it clicks
noticeably in place.
Removing the battery pack:
1. Press the release button
battery pack .
17

Charging the battery pack

Q
NOTE
The battery pack
17
u
Charge the battery pack
ideally at least 60 minutes.
Always pull out the plug of the charger
u
from the mains before removing or connecting
the battery pack 17
Never charge the battery pack
u
the ambient temperature is below 10 °C or
above 40 °C.
Never recharge a battery pack
u
immediately after rapid charging. This could
overcharge the battery pack
the lifespan of the battery pack
charger .
21
Rest the charger 21
u
between successive charging sessions.
If no battery pack 17
u
charger and the charger is connected to
21
mains, the charging status LED
to the battery
17
and remove the
19
comes partly charged.
prior to first use,
17
21
to the charger.
when
17
17
again
, thus reducing
17
and
17
for at least 15 minutes
is inserted into the
flashes green.
22
GB / MT 53