2.3 Adjusting the cutting height (see figure 4)
Without an attachment comb, the default cutting height is 0 mm. It can be
adjusted up to 1.6 mm by pressing the adjustment lever (G).
There are six possible cutting heights: 0 mm, 0.9 mm, 1.1 mm, 1.3 mm, 1.45 mm
and 1.6 mm.
To adjust the cutting height, proceed as follows:
Turn the knurled knob (B) to the "lock" position (fig. 4a).
Press the lever (fig. 4b) to select the desired cutting height among the
6 heights available. To free the adjustment lever (G), release the locking knob
(B) (fig. 4c).
2.4 Using the attachment combs
The cutting length can be increased by using attachment combs (fig 4d).
4 attachment combs are available, giving cutting lengths of 3, 6, 9 and 12 mm.
The clippers must be switched off and unplugged from the power socket
before fitting attachment combs.
Positioning the attachment comb: Slide the attachment comb over the blades
as far as the stop.
Removing the attachment comb: grasp it by the sides and pull it backwards.
17
EN