Check Before Use; Packaging And Materials - INVENTOR COOL Bedienungsanleitung

Maintenance and Cleaning
Cleaning the Exhaust Pipe
Remove the exhaust pipe from the main unit clean and dry, before re-installing. (For step by step
installation and removal refer to " Installation and disassembly of exhaust pipe").

Check Before Use

1. Check for any obstructions on the air inlets and outlets.
2. Check the condition of the power cord and power socket.
3. Check whether filter is clean.
4. Check the batteries of the remote controller.
5. Check if the joints, the window brackets and the exhaust pipe are firmly attached.
6. Check for any damage to the exhaust pipe.
Check After Use
1. Disconnect power supply.
2. Clean filter and main body.
3. Remove any accumulated dust from the unit.
4. Drain any accumulated water (refer to section " Drainage Way").
5. Check if window bracket is damaged. If damaged, contact dealer.
Long time storage
If this unit is inactive for a prolonged period of time, the following steps are suggested:
● Be certain there is no accumulated water, and the exhaust pipe is disassembled.
● Pull out the plug and position the cord properly.
● Clean unit and cover, preventing dust accumulation.

Packaging and Materials

● All materials used for the packing of this unit is made out of recycled materials. Dispose at a
nearby designated recycling facility.
● In the event the unit is faulty or damaged in any way, and need to be disposed, ensure that it is
disposed at a recycling facility that will accept electrical appliances and refrigerant materials.
12