Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TECHNICAL DOCUMENTATION
BANCO: GLISS
N.DOC. QUM000097F
CHAPTER: ADJUSTING CABINET HEIGHT
ADJUSTING CABINET HEIGHT (all versions)
GLISS cabinets have 6 different available positions in height. Proceed as follows:
TWO PEOPLE ARE REQUIRED FOR THIS STEP . USE HEAVY-DUTY GLOVES.BEFORE PERFORMING ANY JOB ON THE
Remove the screws fastening the base deck to
the front and rear part of the cabinet's base.
Then place the appropriate covers (only if the
cabinet has been lifted more than 80 cm).
Covers are installed to hide the gap that opens
when the cabinet is raised.
ORD.
A
CHAPTER N°: 2
B
C
CABINET, DISCONNECT IT FROM THE POWER MAINS.
REMOVE THE FILM FROM ALL PLEXIGLAS SURFACES
GENERAL REVISION STATUS
FORWARDING DOCUMENT
DATE
CAUTION
Lift the cabinet at the front and rear and again,
hold it in position using the appropriate fasten-
ing screws.
Warning: in order to make this procedure easi-
er for two people, tilt and lift the front and then
the rear of the cabinet.
1/2
PAGE N°
Werbung
Inhaltsverzeichnis
