Textron Ransomes G-Plex II series Sicherheits Und Bedienungs Anleitung Seite 12

GB
• This procedure MUST be performed as
specified and only by properly trained
service personnel.
Adjusting the speed control screw out (increasing
length) will reduce the mow speed. Adjusting the
speed control screw in (shortening length) will
increase mow speed.
Determine which direction to adjust the mow speed
screw. Loosen the locking nut and adjust speed
control screw, snug up the locking nut and run the
time test again, repeat as necessary. When correct
mow speed has been obtained, tighten the locking
nut (See Fig. 19).
1
Figure 19
1. Mow Speed Adjustment Screw
2. Locking Nut
TO SET BELLCRANK STOP SCREW:
NOTICE
• The bellcrank stop screw has been set at
the factory and should NOT require
adjustment. If stop screw is loosened or
removed, it MUST be properly installed
and adjusted prior to unit operation.
2
1
Figure 20
1. Bellcrank Stop Screw
2. Center Foot Panel
Remove the screws securing the center foot panel
GB-10
WARNING
2
RANSOMES G PLEX II Series :WD
MAINTENANCE AND PARTS MANUAL
and remove panel (this will allow access to the
lockout link angle).
Loosen the nut on the bellcrank stop screw just
enough to allow the screw to be slid to the left of the
slot (See Fig. 21). Rotate bellcrank clockwise (as
viewed from above) and hold the bushing on the
lockout link angle to the left end of the lockout link
slot (See Fig. 22).
BELLCRANK
STOP SCREW
1
Figure 21
1. Bellcrank
2. Lockout Link Angle
3. Lockout Link slot
POSITIONED
TO THE
LEFT OF SLOT
Figure 22
Position Bushing to Left of Slot
Slide the bellcrank stop screw to the left of the slot
located in the foot panel (See Fig. 20) making sure
the bellcrank contacts the stop screw. With the
screw held tightly against the bellcrank, tighten the
stop screw nut.
Install the center foot panel.
CUTTING HEAD LIFT AND LOWER TIMING
AS VIEWED
FROM BELOW
2
3
LOCK
OUT LINK