Watching The Picture; Before You Start; Switching The Input Signal - Sony PFM-42B1 Bedienungsanleitung

Watching the Picture

Watching the Picture

Before you start

• Turn on the display.
• Turn on the connected equipment and play a video
source.
• To display the input signal information on the screen
when turning on the power or switching the input
signal, set "DISPLAY" in the CONFIG (1/2) menu
to ON.
• To select the on-screen language used in the menu,
see page 36 (GB).

Switching the Input Signal

1
Press MENU.
The main menu appears on the display panel.
M A I N M E N U
I N P U T S E L E C T
P I C C O N T R O L
P I C S I Z E
C O N F I G
M E M O R Y
R E M O T E
S T A T U S
S E L E C T S E T
2
Press v / V to move the cursor (B) to "INPUT
SELECT" and press ENTER.
The currently selected input signal and INPUT
SELECT menu appear on the display panel.
P A L
V I D E O C O M P O S I T E
I N P U T S E L E C T
I N P U T 1 R G B
I N P U T 1 Y U V
I N P U T 2 R G B
I N P U T 2 Y U V
V I D E O C O M P O S I T E
V I D E O Y / C
S E L E C T S E T
3
Press v / V to move the cursor (B) to the input
source to be displayed and press ENTER.
INPUT1 RGB: Selects the audio and video signal
input from the INPUT1 connectors when
the input signal is an RGB signal.
INPUT1 YUV: Selects the audio and video signal
input from the INPUT1 connectors when
the input signal is a component signal.
INPUT2 RGB: Selects the audio and video signal
input from the INPUT2 connectors when
the input signal is an RGB signal.
24
(GB)
ENTER E N D MENU
ENTER E N D MENU
INPUT2 YUV: Selects the audio and video signal
input from the INPUT2 connectors when
the input signal is a component signal.
VIDEO COMPOSITE: Selects the audio and
video signal input from the COMPOSITE
IN connector and AUDIO IN jack among
the VIDEO connectors.
VIDEO Y/C: Selects the audio and video signal
input from the Y/C IN connector and
AUDIO IN jack among the VIDEO
connectors.
(For the PFM-42B1E/42B2E, VIDEO
COMPOSITE and VIDEO Y/C only appear when
the BKM-B10 video input adaptor or BKM-B13
video input & control S adaptor (not supplied) is
installed.)
INPUT3 RGB: Selects the input signal (RGB
signal) from the device connected to the
INPUT 3 connector. (Only when the
BKM-B12 component adaptor is
installed.)
INPUT3 YUV: Selects the input signal
(Component signal) from the device
connected to the INPUT3 connector.
(Only when the BKM-B12 component
adaptor is installed.)
INPUT3 PC: Selects the signal from the BKM-
B30NW network adaptor installed in the
VIDEO connector unit.
(Only when the BKM-B30NW network
adaptor is installed.)
The selected input signal appears on the display
panel.
Color system or horizontal/vertical frequency
Signal type
P A L
V I D E O C O M P O S I T E
You can also switch the input signal using the
Remote Commander.
Note
We recommend input source video equipment
equipped with a TBC (time base corrector). If the
display receives a signal without TBC, the picture
may disappear due to disturbance of the sync signal.