Fuel Specifications; Handling And Transport - Palazzetti MULTIFIRE 45 ARIA Installations- Und Wartungsanleitungen

3 FUEL SPECIFICATIONS

wood pellets.
3.1 PELLET
Pellets are made
mechanically compacted wood in compliance with
environmental protection standards. Pellets are
the only fuel that can be used on this type of stove.
vary in relation to the type and quality of pellets
used.
The pellet stove requires pellets with the following
characteristics:
• Diameter ~ 6 mm;
• max. Length 30 mm;
•
The stove has a pellet hopper with the capacity
Booklet enclosed.
The pellet hopper is located at the top of the stove.
It must always be able to be opened to load the
pellets, and must remain closed during operation.
The stove must not be used as a rubbish incinerator.
3.1.1 STORING THE PELLETS
The pellets must be kept in a place that's dry and
not too cold.
It's suggested to keep some sacks of pellets in
the same room where the stove is installed or an
adjacent room, as long as the temperature and
humidity are acceptable.
Damp and/or cold pellets (5°C) reduce the fuel
heat value and mean the burn pot (unburned
frequently.
Pay special care when storing and handling the
sacks of pellets. Make sure these are not crushed
to prevent the pellets from becoming sawdust.
Sawdust introduced into the hopper may block the
pellet feed system.
Use of poor quality pellets may affect normal pellet
stove operation and render the warranty void.
The features of the pellets must comply with
the requirements of EN 14961-2.
3.2 WOOD
Every type of wood has different characteristics,
this usually contains high quantities of resinous
The following cannot be burned: wood scrap, bark,
painted wood, panels, charcoal, plastics; in these
cases, the warranty on the appliance will be void.
22
INTRODUCTION
from various types
004775230 12/2016
IMPORTANT: continuous and extended use of
wood with a considerable aromatic oil content
(e.g. eucalyptus, myrtle, etc.) will cause a sudden
deterioration in the internal components making up
the product.
Rated heat output in kW can be achieved by burn
ing the correct quantity of wood, making sure not
of
to overload the combustion chamber.
The maximum moisture content allowed is
20%.
Use average-sized pieces of split wood, ideally
30 cm long. The wood must be placed in the
Never load more wood than indicated in the
Pay careful attention when placing the pieces of
wood, to make sure these do not obstruct the
pellet feed tube.
The reference standard for the fuel used is EN
3.2.1 Storing the wood
Keep the logs of wood in a dry place.
It's suggested to keep some logs in the room where
the stove is installed or an adjacent room, as long
as the temperature and humidity are acceptable.
Moist logs reduce the fuel's heat value and mean
more frequent maintenance and cleaning of the
4 HANDLING AND
TRANSPORT
The stove is delivered complete with all parts
included.
Beware of the tendency of the stove to tip over.
When lifting avoid jolts or sudden movements.
Make sure that the forklift capacity exceeds the
weight of the stove being lifted.
The operator of the forklift or other hoisting
equipment is responsible for lifting the loads.
Prevent children from playing with the packaging
suffocation!
4.1 REMOVING THE STOVE FROM THE
PALLET
To remove the stove from the transport pallet
follow the instructions shown in the "Product
Booklet" enclosed.