Operation - Ryobi RBV3000CSV-01 Originalanleitung

and sharp edges.
■
Always direct the cable to the rear away
from the product.
■
Make sure voltage is correct for your
product. A nameplate on the product
indicates the unit's voltage. Never connect
the product to an AC voltage that differs
from this voltage.
■
Make sure the switch is in Off position
before disconnecting from power supply.
PREPARATION
■
Some regions have regulations that restrict
the use of the product to some operations.
Check with your local authority for advice.
■
While operating the product always wear
substantial footwear and long trousers.
Do not operate the product when barefoot
or wearing open sandals. Avoid wearing
clothing that is loose fitting or that has
hanging cords or ties; they can be caught
in moving parts.
■
Do not wear loose clothing or jewellery that
can be drawn into the air inlet.
■
Secure long hair so it is above shoulder
level to prevent entanglement in moving
parts.
■
Wear hearing protection at all times while
operating the product. This product is
extremely noisy and permanent hearing
injury may result if precautions to limit your
exposure, reduce noise and wear hearing
protection are not strictly adhered to.
■
Wear full eye protection at all times while
operating this product. The manufacturer
strongly suggests a full face mask or fully
enclosed goggles. Normal spectacles or
sun glasses are not adequate protection.
Objects can be thrown at high speed by
the powerful air jet at any time and may
rebound from hard surfaces toward the
operator.
■
Ensure before each use that all controls
and safety devices function correctly. Do
not use the tool if the "off" switch does not
stop the product.
■
Before each use, always inspect to see
that bolts and other fasteners are secure
(if applicable), the housing is undamaged,
and the guards and handles are properly
in place.
■
Return to an authorised service centre to
| English
2
replace damaged or unreadable labels.
■
Never operate the product with defective
guards or shields, or without safety devices,
for example debris collector, in place.
■
Keep all cooling air inlets clear of debris.
■
Use rakes and brooms to loosen debris
before blowing/vacuuming.
■
Clear the work area before each use.
Remove all objects such as rocks, broken
glass, nails, wire, or string which can be
blown a considerable distance by high
velocity air.
■
Operate the product on a firm, level surface
only.
WARNING
Before using the product in vacuum mode
you must assemble the upper and lower
vacuum tubes together as shown on page
7. This is a one-time operation only. Never
operate the vacuum with only the upper
vacuum tube fi tted. The risk of personal
injury is signifi cantly increased if you fail to
follow this warning.

OPERATION

■
If the cord becomes damaged during
use, disconnect the cord from the power
supply immediately. Do not touch the
cord before disconnecting the power
supply. Do not use the product if the cord
is damaged or worn.
■
Operate the product only at reasonable
hours – not early in the morning or late at
night when people might be disturbed.
■
Never operate the product in an explosive
atmosphere.
■
Avoid using the product in bad weather
conditions especially when there is a risk
of lightning.
■
Do not operate in poor lighting. The
operator requires a clear view of the work
area to identify potential hazards.
■
Use of hearing protection reduces the
ability to hear warnings (shouts or alarms).
The operator must pay extra attention to
what is going on in the working area.
■
Do not get distracted
concentrate on what you are doing. Think
about and consider the effect of your
and always