MRC E5CN Bedienungsanleitung Seite 13

of heating is switched off at a level of regulation the device does not display this
parameter.
prst: start of the program (status). If with "down D" or "up U" keys we will set:
prst prst prst
program will be stopped. This is a "reset" status.
If we will set:
prst prst
prst prst
strt strt strt strt
furnace automatically. When the program is finished, in SV No.1 display the note " end
is blinking. The device is required to be set on the "reset" status.
sktr: displays the time (in minutes) till finish of heating. For example: if up to the end of
sktr sktr sktr
program there are 5 minutes the device displays:
furnace
is not in the set range of temperature the certain time, this time is not included to the time
of heating.
rs: heating switching on/off. If we will set:
rs
rs rs
with the set speed to the fixed working temperature. Temperature will be constant until
regulator will be switched off manually, set to
should be equal to furnace maximum temperature
Level of regulation is switching on/off by short pressing of the level key. Parameters are
switching by short pressing of the parameters key. Values of parameters are setting by
"down D" and "up U" keys.
T
°C
0
at: automatic selection of parameters (parameters of PID combination: p p p p , i i i i , d d d d ) of
at at at
temperature regulation (further in text: AT). If the temperature in the chamber of furnace
changes and is unstable it is required to switch on АТ. AT can be switched on only when
regulator executes the program.
When AT is switched :
switches off AT automatically when selects parameters of PID combination. It is
recommended to select p p p p , i i i i , d d d d parameters at operating temperature.
ins: Movement of value of temperature which is shown on PV No 1display. It should be:
ins ins ins
ins ins ins ins
0.0 0.0 0.0 0.0
regulator will perform the set program and will switch off heating of
4. Level of adjustment l.adj
time of keeping
at at
at at
at at
at at
or
at- - - - 1 1 1 1 at at at
at at at at- - - - 2 2 2 2
If temperature in the chamber of
sktr sktr sktr sktr
5 5 5 5
r r r r- - - - s s s s r r r r- - - - s s s s
(if
run run run run Rrset Rrset Rrset Rrset
status. Parameter al
r r r r- - - - s s s s
stop stop stop stop
l.adj
l.adj l.adj
End
SV No.2 display is blinking. The regulator
prst prst prst prst
end ".
end end
), furnace will heat up
al- - - - 2 2 2 2 value
al al
range of temparature
time , min.
rset rset rset rset