LELY SPLENDIMO PC 320 Betriebsanleitung Seite 50

50
Assembly of the cutter bar takes place in the reversed order.
Mind the directions listed hereafter:
- Clean the centring rings (10) and the contact areas of the
mower elements and intermediate spacers.
- Make sure that there is no contamination between those
elements and spacers which were not dismounted (rub the
sides with Castrol Tarp).
- Grease the drive shaft (Molykote BR2 Plus)
Make sure that the mower discs are turned 90° in respect
!
of one another. If a unit can not be slid onto the drive shaft
in one go, its disc needs to be turned a semi-turn one or
several times until the unit can be placed.
- Fit the elements in the standard configuration of directions
of rotation (fig. A-2).
• A RH rotation SPLENDIMO PC element can be identi-
fied as follows:
When the hub is turned to the right (R - fig. A-3) the
drive gear on the RH side will turn anti-clockwise.
• A LH rotation element can be identified as follows.
When the hub is turned to the left (L - fig. A-3), the drive
gear on the RH side will also turn anti-clockwise.
- After disassembly of a mower disc, check at the catellated
nut the presence of the O-ring D (11, fig. A-1) in the
pressure piece.
- Tighten the castellated nut (12) with a torque of 150-250
Nm (15-25 kgm) and secure it with a split pin. Make sure
that the split pin does not protrude above the pressure
piece.
- The securing disc (13) and supporting ring have to be fitted
in the outer mowing element. If this element is replaced,
these parts need to be moved over to the new unit.
- First, tighten the 5 bolts (14) by force of hand.
- Grease (Molykote P74) the ring (8) as well as to the
threaded part of the connecting rod (3) and nut (7). Fit the
nut on the rod.
Supplement A
SPLENDIMO
SPLENDIMO
®
281 PCN
®
320 / 321 PCN
L
R
A-2
A-3