Assigning Names To The Sources - JVC kd-sh99r Bedienungsanleitung

Assigning names to the sources

You can assign names to CDs and the external
components.
After assigning a name, it will appear on the
display when you select the source.
Sources
CDs*
External components up to 10 characters
(LINE INPUT and
AUX INPUT)
* You cannot assign a name to a CD Text or an MP3 disc.
1
Select a source you want to assign a
name to.
2
Press and hold SEL (select) for
more than 2 seconds while pressing
D (display).
When you select "CD PLAY" as the source
34
Maximum number of
the characters
up to 32 characters
(up to 40 discs)
Each time you press the
button, the source changes
as described on page 7.
3
Select the character set you want while
" " is flashing.
Each time you press the button,
the character set changes as
follows:
Capital letters (
Numbers and symbols (
4
Select a character.
About the available
characters, see page 45.
5
Move the cursor to the next
(or previous) character position.
6
Repeat steps 3 to 5 until you finish
inputting the name.
7
Finish the procedure while the last
selected character is flashing.
To erase the input characters
Insert spaces using the same procedure
described above.
Notes:
• When you try to assign a name to the 41st disc,
"NAME FULL" appears on the display. (In this
case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign
names to discs in the CD changer. These names can
also be shown on the display if you insert the discs
in this unit.
)
Small letters ( )
)