Duox Amplifier Calling Codes; Calling A House From The Direct Panel - Fermax DUOX Installations- Und Programmieranleitung

DUOX Amplifier Calling Codes.

The DUOX system uses 6 digit house terminal addresses. This provides a lot of flexibility
when numbering terminals in each country´s established numbering system. These call
code digits are organised as follows: BBSSNN:
• BB indicates block number.
A block is a group with a maximum of 9999 residences. The value ranges from
BB=00 to 99, so up to 100 blocks may be available.
• SS indicates sub-block number.
A sub-block is part of a block which you may want to sub-divide for organisational
purposes. Each sub-block may contain 99 terminals and up to 100 sub-blocks
(SS=00..99). A sub-block may be a building, a story in a building or a housing
complex area.
• NN indicateshouse number in the sub-block.
It may range from 00 to 99.
You do not have to segregate the installation according to this hierarchy since the system
adapts to the installation´s needs.
The street panels may be configured as follows, (See «Street panel configuration»):
• General Entrance [G]. This allows for a calling range from 000001 to 999999.
• Block entrance [B]. This allows for a calling range from 0001 to 9999.
• Sub-block entrance [S]. This allows for a calling range from 01 to 99.
Each panel may also have a different number on each block, sub-block or general
entrance, which goes from 0 to 9. The default value is 0.
• The house terminal´s address is encoded with 6 digits (calling code). The default
value is 000000, (not programmed).
• Panels with an address "0" in each block allow for communication with telephones
when picked-up or with the monitors doing an auto-start with it and the
communication lines are free. If you do not want this feature do not assign this
address to any panels. The monitors also have the option of an auto-start with
panel 1 in you block and panel 0 of the General Entrance.

Calling a house from the Direct Panel

Enter the house number via the keypad and press .
The last 6 digits entered before pressing are noted. Depending on the street panel´s
configuration and the digits entered, you may make the call or not.
Upon programming each phone, it inherits the upper part of the address the street panel
has assigned, if it isn´t a general entrance panel.
Examples:
• Panel configured as Block
Block 25, range of telephones25XXXX.
• Panel configured as Block + Sub-block
Block 12 / Sub-block 03, range of telephones 1203XX.
• Panel configured asGeneral Entrance
General Entrance, range of telephones XXXXXX (000001 to 999999).
Pag 54