Panasonic ES-DEL8A Betriebsanleitung Seite 12

Tips for best epilation results
The hair removal is not permanent, so
from the second use, it is
recommended to epilate the underarms
about once a week, and the bikini‑line
about once every two weeks.
<For beginners/those with sensitive
skin>
ES-DEL8A/ES-EL8A / ES-EL3A
Using the gentle cap that comes with
the skin guard is recommended for
people using the epilator for the first
time or for those with sensitive skin.
The gentle cap has a skin protector for
gentler epilation, to remove hair by
holding the skin down to reduce pain.
• We also recommend to use the SOFT
mode rotation. (
1. Remove the fast cap [
2. Attach the gentle cap [
• Massaging with a body puff may help
to prevent ingrown hairs.
• Reddening might appear after use. A
cool towel will help if you feel pain or
there is a rash.
• If your skin gets dry after epilation, we
recommend applying a moisture lotion
two days after epilation.
• Make sure skin is clean before and
after use.
<Best hair length for epilation>
Trim your hair before epilating for the
first time or if you have not epilated for
a long time. Hair removal is easier and
less painful when the hair is short.
18
PB015615 - EL8A-3A-2A _(01GB)_11-07-17.indd 18
Page 16)
A ].
B ]. (Fig. 15)
Shaver head
ES-DEL8A/ES-EL8A
WET Shaving with soap lather makes
the skin slippery for a closer shave. For
DRY shaving, step 3 is unnecessary.
Before DRY shaving, wipe dry any
moisture or sweat from the skin.
1
1
Attach the shaver head [
• Confirm the bikini comb [
detached.
2
2
Check that the outer foil is not
deformed or damaged.
3
3
Wet your skin and put shower
gel on your skin.
• Do not use a shower gel with a
scrub or with granular salt. Also do
not use shaving cream, skin
cream or skin lotion.
Doing so may clog the blade and
cause a malfunction.
4
4
Select the mode by pressing
the power switch [
• Press gently so that the whole
blade is in close contact with the
skin and the surface of the blade
does not move up and down.
Foot care head
ES-DEL8A/ES-EL8A
• The foot care head cannot be used in a
bath or shower.
• Before use, be sure to fully charge the
appliance.
• We recommend using the product
within 30 minutes after bathing or
showering. With the feet clean, wipe off
any water on the skin. (Each use
should be approximately 10 minutes
(5 minutes on each foot, 10 minutes
total for both feet))
1
1
Attach the foot care head [
• Push down firmly until you hear a
"click".
2
2
Press the power switch [
thrice. (Fig. 16)
• POWER mode is recommended
for rotation speed. (
].
F
E ] is
].
I

].
H
]
I

Page 16)
2017/11/7 11:11:22