Installation - Bimar Vm43 Bedienungsanleitung

automatically, to avoid risk of fire, since a fire risk exists if the
heater is covered or positioned incorrectly.
 In the event of a breakdown or poor operation, turn the fan
heater off and ask for professionally qualified help: repairs
made by unqualified persons can be dangerous and render
void the warranty.

INSTALLATION

 After removing the packing materials, check the integrity of the appliance; if
you are unsure, do not use it and ask for qualified professional help. The
packing materials (plastic bags, polystyrene foam, nails, etc.) must be kept out
the reach of children because they are potential sources of danger. Attention:
any stickers or advertising material applied to the grid removed before using
the appliance. The manufacturer declines all responsibility in case this is not
safe working practices will be respected.
 Before connecting the appliance, check that the voltage values shown on the
data plate correspond to those of the electricity supply network. In the event
of incompatibility between the electric outlet and the plug of the appliance,
have the outlet replaced with another more suitable type by professionally
qualified personnel, who will make sure that the section of the wires of the
outlet is appropriate for the absorbed power of the product. In general, the use
of adapters or extension cords is not recommended; if their use is
indispensable, they must conform to existing safety standards and their
current capacity (amperes) must not be less that the maximum of the
appliance.
 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 To not place the appliance near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
 Do not place the appliance near an open flame, cooking or other heating
appliance.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
 Do not place the wall fan into the room to avoid the back-flow of gases from
the open flue of gas or other fuel-burning appliances (for duct and partition
fans).
14/48