Operating Elements; Preparation; Filling With Water; Plugging In And Ironing - Lervia KH 1282 Bedienungsanleitung

IB_KH1282_E5554_UK_5

Operating Elements

q
Spray button
w
Heating control lamp
e
Power cable with plug
r
Flexible cable restrainer
t
Back end
y
Water tank
u
Temperature controller
i
Sole of the iron
o
Water fill opening
a
Water jet
s
Steam controller/Self Clean
d
Steam blast button
f
Measuring beaker

Preparation

Filling with water

You require water to be able to use the steam and
spray functions. Water is not needed for dry ironing.
• Place the cooled down iron in an upright position
t
on its back end .
• Open the water fill opening
y
.
• Using the measuring beaker
no further than the "Max" marking in the water
y
tank .
• Close the water fill opening
y
.
Should the mains water at your locality be rated as
hard, it is recommended that you mix mains water
with some distilled water. Otherwise, the jets for the
steam blast function could calcify (become blocked)
prematurely.
06.09.2007 15:32 Uhr
o
for the water tank
f
, pour in water to
o
for the water tank
- 26 -
Seite 26
To extend the optimal steam blast function, mix
mains water with distilled water according to the
table.
local water
Ratios - distilled
water to mains water
hardness
very soft / soft
medium
hard
very hard
The water hardness level can be queried at your lo-
cal water works.

Plugging in and ironing

Ironing tips
Sort the laundry in accord with the type of material.
Always observe the ironing and care instructions
given for the material. Start with the materials that
require the lowest heat settings.
If you are not sure what material has been used in
the garment, first of all carefully iron a small area
(hem-piece or an inner edge). In cases of serious
doubt, start with a low iron temperature. If creases
remain, slowly increase the heat level in steps.
When you have found the temperature which gives
the best ironing results, do not increase the
temperature further. Never raise the temperature so
high that the material of the garment could be
damaged.
0
1: 1
2: 1
3: 1