Cleaning And Maintenance - Ferm PSM1026 Bersetzung Der Orginalbetriebsanleitung

Removing
● Open the sanding paper clamps (4).
● Remove the sanding paper (7) from the
sanding pad (3).
● Close the sanding paper clamps (4).
USE
Switching on and off (fig. A)
● To switch on the machine, press the on/off
switch (1).
● To switch the machine to continuous mode,
keep the on/off switch (1) pressed and
simultaneously press the lock-on button (2).
● To switch off continuous mode, press the on/off
switch (1) again.
● To switch off the machine, release the on/off
switch (1).
Dust extraction (fig. C)
● Insert the dust extraction adapter (9) into the
dust extraction connection (7).
● Connect the hose of a vacuum cleaner to the
dust extraction adapter (9).
Hints for optimum use
● Clamp the workpiece.
● Firmly hold the machine with both hands.
● Switch on the machine.
● Place the sanding pad with sanding paper on
the workpiece.
● Slowly move the machine over the workpiece,
firmly pressing the sanding pad against the
workpiece.
● Do not apply too much pressure on the machine.
Let the machine do the work.
● Switch off the machine and wait for the machine
to come to a complete standstill before putting
the machine down.

CLEANING AND MAINTENANCE

4
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
● Regularly clean the sanding pad to avoid
inaccuracies during use.
Ferm
Replacing the sanding paper (fig. B)
● To remove the old sanding paper (8),
proceed as described in the section
„Mounting and removing the sanding paper".
● To mount the new sanding paper (8),
proceed as described in the section
„Mounting and removing the sanding paper".
Replacing the sanding pad (fig. D)
In case of wear, the sanding pad must be replaced.
● If necessary, remove the sanding paper.
● Loosen the screws (10) from the sanding pad
(3).
● Remove the old sanding pad (3).
● Mount the new sanding pad (3).
● Tighten the screws (10) to the sanding pad (3).
wARRANTy
Consult the enclosed warranty terms.
ENVIRONMENT
Disposal
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
EN
7