Warranty; Cleaning And Maintenance - Ferm AGM1102 Bersetzung Der Originalbetriebsanleitung

Mounting and removing the auxiliary grip
(fig. C)
Mounting
• Tighten the auxiliary grip (6) into one of the
mounting holes (13).
Removing
• Loosen the auxiliary grip (6) from the mounting
hole (13).
USE
Switching on and off (fig. A)
• To switch on the machine in continuous mode,
slide the on/off switch (1) in the direction of the
grinding disc.
• To switch off the machine, press the lower part
of the on/off switch (1).
Hints for optimum use
• Clamp the workpiece. Use a clamping device
for small workpieces.
• Draw a line to define the direction in which to
guide the grinding disc.
• Hold the machine with both hands.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the grinding disc on the workpiece.
• Slowly move the machine along the pre-drawn
line, firmly pressing the grinding disc against
the workpiece.
• Do not apply too much pressure on the
machine. Let the machine do the work.
• Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.

CLEANING AND MAINTENANCE

Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
• Regularly clean the housing with a soft cloth.
• Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
8
Only use sharp and undamaged grinding
discs.
Carbon brushes
If the carbon brushes are worn, the carbon
brushes must be replaced by the customer
service department of the manufacturer or a
similarly qualified person.

WARRANTY

Consult the enclosed warranty terms.
ENVIRONMENT
Disposal
The product, the accessories, and the
packaging must be sorted for
environmentally friendly recycling.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.