Getting Started; Powering The Unit - Waterpik WP-660 Handbuch

6

GETTING STARTED

Fill
ON
OFF
Eject
ON ON
Power
OFF OFF
ON
ON
High
OFF
Water
ON
Floss
Massage
Low
ON
OFF
Water
ON

Powering the Unit

Plug the cord into an electrical outlet.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill with lukewarm water.
Replace the reservoir over the base and press down firmly and close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down firmly
until the tip clicks into place. The colored ring will be flush with
the top of the handle if the tip is correctly locked into place. To
remove tip from the handle push the tip eject button on the handle.
Prime Unit (First Time Use Only)
Set pressure control dial on base to pressure setting No.10, point the
handle and tip into sink. Turn power and water ON until water flows from the
tip. Turn Power OFF.
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting
for first-time use. Gradually increase pressure over time to the setting you
prefer – or as instructed by your dental professional.
Using the Water Flosser
Always place the tip in your mouth before turning the water ON.
Turn power on, lean over sink and slightly close lips enough to
prevent splashing while still allowing water to flow from mouth
into the sink. Turn water switch ON. When finished, turn
water switch and power OFF. During use you can stop the flow of water
by sliding the water switch on handle to the OFF position.
NOTE: Motor will continue to run.
For best results, start with back teeth and work toward the front teeth. Direct
the stream at a 90-degree angle to your gumline with tip in mouth. Glide
tip along gumline and pause briefly between teeth. Continue until you have
cleaned the inside and outside of both the upper and lower teeth.