Makita VC1310L Bedienungsanleitung Seite 10

NOTE:
Models VC2510L and VC3210L have no mounting
•
position marking and no need to align it.
Installing the paper pack
WARNING:
When using the paper pack, also use the prefilter
•
together that is preinstalled on the tool. Failure to
use the prefilter together may cause unusual noise
and heat, resulting in a fire.
CAUTION:
Never pick up water or other liquids or wet dusts
•
when using the paper pack. Picking up such things
may cause the paper pack breakage.
Fig.12
1. Remove the rubber holder.
2. Extend the paper pack.
Fig.13
Fig.14
3. Align the paper pack opening with the dust suction
opening of the cleaner.
4. Insert the cardboard of the paper pack onto the
tool so that it is positioned at the end beyond the
detent protrusion.
Installing the pipe holder (optional accessory)
For Model VC1310L only
Fig.15
Depress the cord hook as shown in the figure.
1
1. Press
2. Pipe holder
3. A section
4. Hooks
5. Tank cover
011605
Attach the pipe holder onto the cord hook. (The hooks
are away from the tank cover.)
Raise the pipe holder as far as the hooks contact the tank
cover and press the A section of the pipe holder.
2
4
5
Fig.16
Press the A section with a great force and with the A
section so pressed lower the pipe holder.
Fig.17
Fig.18
Fit two protrusion of the pipe holder into the grooves of
the tank cover and then press down the pipe holder.
Fig.19
NOTE:
The pipe holder that is excessively lowered than
•
the intended position cannot be installed on the
cord hook with the hook away from the tank cover
as shown in the figure.
Fig.20
NOTE:
Make sure that the two hooks of the pipe holder are
•
hooked on the tank cover securely.
Connecting a hose
CAUTION:
Never force the hose for bending or stamp it. Never
•
move the cleaner by a hose. Forcing, stamping and
pulling the hose may cause a breakage or
deformation of the hose.
When picking up large wastes such as planer
•
carvings, concrete dusts or similars other than
small wastes, use the 38 mm inner diameter hose
(optional accessory). Using the 28 mm inner
diameter hose may cause a hose stuffing and
damage.
Fig.21
Insert the hose onto the mounting port of the tank and
turn it clockwise until it locks.
3
Installing polyethylene bag
Cleaner can also be used without polyethylene bag.
However, using polyethylene bag is easier to empty the
tank without letting your hands dirty.
Fig.22
Spread the polyethylene bag in the tank. Insert it
between the holder plate and the tank, and pull it to the
hose inlet.
Fig.23
Spread the bag around the top of the tank.
Hook up the other side of the bag around the top of the
tank so that the prefilter hook can catch and hold it
securely
NOTE:
A polyethylene bag available on the market can be
•
used. The 0.04 mm or thicker one is recommended.
Too much dust will tear the bag easily, so do not
•
collect the dust more than the half of the bag
capacity.
10