Preparation For Operation - GRAPHITE 59G880 Betriebsanleitung

17. Bevel angle scale
18. Switch
19. Leg fixing screw
20. Tray
21. Water pump
22. Clamp
23. Clamp knob
24. Laser switch
25. Battery compartment
27. Power indicator
28. RESET button
29. TEST button
* Differences may appear between the product and drawing.
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Base
2. Leg
3. Mitre gauge
4. Cutting length locking unit + knob
5. Tile holding unit
6. Ring spanner
7. Screw
8. Knurled head screw
9. Tray
10. Clamp
11. Screw + clamp knob
12. Hexagonal key (8 mm)
Ceramic tile saw is supplied disassembled. Take items out of the package and assemble in the below described order.
CERAMIC TILE SAW ASSEMBLY
● Use the screws (included) to attach the legs (6) to the base (5) (fig. A).
● Put the screws into holes at both sides of the base (
● Put the tray ( 20) on the base (5) and fix it with clamps (22) by joining tightly clamp knobs (23) to previously inserted
screws (fig. B).
● Put the saw in the tray (
● Attach the locking knobs for cutting length limiter (
● Use knurled head screws (
of the work able) (fig. H).
● Unscrew the head locking knob (
Before using the tile saw unscrew the head locking knob and remove the transport screw, otherwise moving the
head with cutting blade will be impossible. The water pump should be immersed in water during cutting.
- 1 pce
- 4 pcs
- 1 pce
- 2 sets
- 1 pce
- 2 pcs
- 4 pcs
- 2 pcs
- 1 pce
- 2 pcs
- 2 sets
- 1 pce

PREPARATION FOR OPERATION

20). Be careful to fix the water pump (21) in appropriate hollow in the tray (fig. C).
1) (fig. D).
8) to join the mitre gauge (10) to the fence (7) (you can install the mitre gauge on both sides
15) (fig. E) and the transport screw (16) (fig. F).
5).
14