Mounting The Camera In The Adaptor; Mounting Procedure - Sony HDLA1500 Handbuch

[1500][1507]

Mounting the Camera in the Adaptor

Notes
• Be sure to turn off the camera power before mounting.
• If the camera is mounted with the power ON, the
protection circuit of the adaptor will be activated. In such
a case, unmount the camera from the adaptor, turn off the
power, wait for more than 30 seconds, then mount it
again.

Mounting procedure

While the figures of the adaptors in the following steps
show the states where the studio lens and the large
viewfinder are not attached, the camera can also be
mounted after attaching the large lens and the large
viewfinder to the adaptor.
For the HDLA1507, start from step 2.
1
Check that the camera lock lever on the front panel is
in its upper position.
Remove the blind
bush from the
screw hole on the
side panel.
2
Attach the stopper
using the supplied
screw.
3
4
5
[1500][1505]
For the HDLA1500, proceed to step 2.
For the HDLA1505, proceed to step 3.
Pull the viewfinder table lock lever 1 toward the rear
panel, then pull the release knob 2 and slide the
viewfinder table in the direction of the arrow 3.
[1500][1507]
1
2
Push the rear panel lock release lever on the left panel
down to open the rear panel.
1
(The figure shows HDLA1500.)
Remove the viewfinder from the camera (if attached).
Mount the camera.
For the HDLA1500/1505
1 Remove the lens (lens cap) from the camera and
push the lens mount lever fully downward.
Camera lock
lever
3
2
39
Installation