Connecting The Cuff To The Monitor; Applying The Cuff; Body Posture During Measurement - Gima 32918 Gebrauchsanweisung

3. connecting the cuff to the monitor

the cuff is attached to the monitor when it is
packaged. should the cuff become unattached,
align the two plugs and four brackets of the cuff
with the plug sockets and bracket sockets of the
monitor and press the cuff to the monitor until
the plugs and brackets are securely
attached.

4. applying the cuff

a. place the cuff around a
the wrist joint on the palm side of the
b. While seated, place the
in front of your body on a desk or
If the cuff is correctly placed, you can
the cuff must be neither too tight nor
Note:
1. please refer to the cuff circumference range in "speCIfICatIons" to make
sure that the appropriate cuff is used.
2. measuring on same wrist each time.
3. do not move your arm, body, or the monitor during measurement.
4. stay quiet, calm for 5 minutes before blood pressure measurement.
5. please keep the cuff clean. If the cuff becomes dirty, remove it from the
monitor and clear it by hand in a mild detergent, then rinse it thoroughly in
cold water. never dry the cuff in clothes dryer or iron it. Clean the cuff after
the usage of every 200 times is recommended.

5. body posture during measurement

Sitting Comfortably Measurement
a. be seated with your feet flat on the floor, and
don't cross your legs.
b. place palm upside in front of you on a flat
surface such as a desk or table.
c. the middle of the cuff should be at the level of
the right atrium of the heart.
ENGLISH
bare wrist 1-2cm above
wrist.
arm with the cuffed wrist
table with the palm up.
read the lCd display. c.
too loose.
26