General; Tools Required For Installation (Not Supplied); Type Of Copper Tube And Insulation Material; Additional Materials Required For Installation - Sanyo SPW-C366VEH Bedienungsanleitung

1. GENERAL

This booklet briefly outlines where and how to install
the air conditioning system. Please read over the
entire set of instructions for the indoor and outdoor
units and make sure all accessory parts listed are
GB
with the system before beginning.

1-1. Tools Required for Installation (not supplied)

1. Standard screwdriver
FR
2. Phillips head screwdriver
3. Knife or wire stripper
4. Tape measure
5. Carpenter's level
DE
6. Sabre saw or key hole saw
7. Hacksaw
8. Core bits
9. Hammer
IT
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
PT
14. Adjustable wrench
15. Reamer (for deburring)
1-2. Accessories Supplied with Unit
GR
See Tables 1-1 to 1-4.
Table
1-1 4-Way Air Discharge Semi-Concealed
ES
1-2 Wall-Mounted
1-3 Ceiling-Mounted
1-4 Concealed-Duct

1-3. Type of Copper Tube and Insulation Material

If you wish to purchase these materials separately
from a local source, you will need:
1. Deoxidized annealed copper tube for refrigerant
tubing.
2. Foamed polyethylene insulation for copper tubes as
required to precise length of tubing. Wall thickness
of the insulation should be not less than 8 mm.
3. Use insulated copper wire for field wiring. Wire
size varies with the total length of wiring. Refer to
5. Electrical Wiring for details.
DC_Inverter_Eng.indd 8 DC_Inverter_Eng.indd 8
Type
Check local electrical codes
CAUTION
and regulations before
obtaining wire. Also, check
any specified instructions
or limitations.

1-4. Additional Materials Required for Installation

1. Refrigeration (armored) tape
2. Insulated staples or clamps for connecting wire
(See your local codes.)
3. Putty
4. Refrigeration tubing lubricant
5. Clamps or saddles to secure refrigerant tubing
6. Scale for weighing
8
2007/07/25 13:21:34 2007/07/25 13:21:34