G/L Input Connector [G/L In]; Cooling Fan - Panasonic AK-HC1800G Bedienungsanleitung

Major operating controls and their functions
 HD SDI output connector [HD SDI OUT]
HD SDI signal output is given by this line.
 G/L input connector [G/L IN]
For gen-lock with the camera, the external sync signal (black burst) or tri-level sync
signal is supplied to this input connector.
 Operate indicator
Green LED lamp lights to indicate that the specified DC 1 V power is supplied to the
interface connector .
 Cooling fan
• Do not block or obstruct the ventilation during operation. It may otherwise cause
internal heating or fire.
• The life of this fan is approximately 0,000 hours (at room temp. 5 °C [77 °F]).
Replace the fan as needed.
(When the room temperature is higher than 5 °C [95 °F], replace the fan 0 %
earlier.)
Be sure to ask the dealer for the replacement.
 Interface connector [I/F]
Pin No.
1 Gen-lock signal GND


4 TX_N (EIA4)/TXD (EIA) output
5 RX_N (EIA4)/RXD (EIA) input
6 DC power supply input (+1 V)
7 Gen-lock signal input
8
9 TX_P (EIA4) output
10 RX_P (EIA4) input
11
1
1
14
15
Signal
Not used
Not used
DC GND
GND
Not used
GND
GND
GND
- 1 (E) -