Inhaltsverzeichnis
Werbung
Wichtige Hinweise Sicherheitsregeln für die Aufstellung
Important and practical information
Avis importants et practiques
Prior to mounting the META shelves it is absolutely necessary to read the information
contained in these instructions as well as the "safety regulations" at the next side of
them. Please follow exactly these instructions, as well as the information contained in
our commission papers and the advice of our qualified staff. Also take notice of the
general accident prevention regulations of the trade and craft associations and the
general regulations of the authorities supervising the enforcement of laws governing
health and safety conditions of work. The parts of the shelves delivered by META must
be mounted according to their special application only. META does not take any
responsibility for incorrect handling, usage or mounting. The conditions for usage and
load-bearing capacity can change when the shelves are remounted in a different place.
In such cases please consult a META specialist in order to avoid damage. There should
always be at least two persons mounting the shelves. A low table or two separate bucks
could be very helpful to place the individual part while pre-mounting the shelves. When
the frame is mounted, please pay attention to the direction of the profile holes on the
front side. While mounting the individual parts, do not use force, e.g. a metal hammer
or metal bars. Only use a rubber hammer or a soft intermediate wooden layer. In order
to avoid turning over, please secure all shelves with a ratio height - depth of more than
5:1. This can be reached by floor pegging. The foundation bolts in our catalogue are
dimensioned so that one dowel should be used per bottom plate. All shelves must be
pegged regardless of their ratio height - depth, if extendible parts or wing doors are
mounted to them (i.e. drawers, extendible registers etc.)
Stand 17/11/2005
Stand 17/11/2005
8
Das Lagersystem
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
