Panasonic WV-CS570/G Bedienungsanleitung Seite 48

10. Move the cursor to RET and press the CAM (SET)
button to return to SET UP.
Important Notices:
• The motion detection should meet the following con-
ditions.
1) The picture size on the screen should be larger
than 1/48 of the actual picture size.
2) The contrast ratio between the object and the
background picture should be more than 5 % at
the maximum detection level.
3) The time that takes the object to move from one
end of the screen to the other should be more
than 0.1 second.
• Also under the following conditions, mask or adjust
the detection level to prevent malfunction.
1) When leaves, curtains, etc. are swayed by the
wind.
2) When a picture has a high noise content due to
low light conditions.
3) When the object is illuminated by lighting equip-
ment that constantly turns on and off.
• The alarm signal will take approx. 0.2 seconds to
reach the alarm terminal of the VTR after the camera
detects the object.
Because the alarm signal is multiplexed on the
video signal, it may be mistakenly interpreted by
other video equipment as a time code signal.
Therefore, when this camera is not used in a
Panasonic Intelligent CCTV System, select OFF to
prevent the above from occurring.
G Auto Focus Setting (AF MODE)
1. Move the cursor to AF MODE, and select the follow-
ing mode with the joystick. S, M and L stand for
Small, Middle and Large areas respectively in the
centre of a scene that are used for sensing sharp-
ness in auto-focusing.
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET
AUTO S
MANUAL L
MANUAL S, M, L: Auto focus is activated only when
the button that is assigned for the auto-focus
function on the controller is pressed.
AUTO S, M, L: Auto focus is activated automatically
while the pan, tilt or zoom operation is manually
performed. These may be selected in the same
way as MANUAL by pressing the button that is
assigned for the auto-focus function on the con-
troller.
2. To confirm auto-focus operation, press CAM (SET)
button.
Notes:
• When the electronic sensitivity enhancement (SENS
UP) is activated except in the x2 FIX or x2 AUTO
mode, this function is automatically set to MANUAL
(S, M, L).
• The auto focus lens does not function properly in the
AUTO mode after using the WIDE lens.
• The auto focus lens may not function properly in the
AUTO mode under the following conditions.
1. Dirt or water on window glass.
The auto focus may focus on the dirt or water.
2. Low lighting or illumination.
3. Bright objects or high intensity objects.
4. Single colour object such as a white wall or fine
felt
5. No centre objects and sloping objects
6. Far and near objects on the screen
-48-
** SET UP **
OFF
ALC
AUTO
ON(MID)
OFF
INT
ATW1
OFF
AUTO L
SPECIAL2
AUTO M AUTO L
MANUAL M MANUAL S