14
WARNING
With alternating load: Use a screw locking device
)
(e.g. LOCTITE
exclude prestressing loss due to screw slackening.
3. Tighten all screws with the specified tightening torque (Table 3.1).
4. For further mounting of the shaft run, there are eight tapped holes on the
rotor. Also use screws of property class 10.9 or 12.9 and fasten with the
tightening torque specified in Table 3.1.
CAUTION
With alternating loads, use a screw locking device to cement the
connecting screws into place. Guard against contamination from
varnish fragments.
Measuring range
Fastening screws
(NVm)
500
1 k
2 k
3 k
5 k
10 k
Table 3.1: Fastening screws
1)
DIN EN ISO 4762; black/oiled/m
3.5 Installing the stator
On delivery, the stator has already been installed and is ready for operation.
The upper antenna segment can be separated from the stator, for example,
for maintenance or to facilitate stator mounting.
If your application does not require the stator to be dismantled, proceed as
described in points 2., 5., and 6.
HBM
no. 242) to glue the screws into the counter thread to
1)
(Z)
M10
M10
M12
M12
M14
M16
= 0.125
tot
Fastening screws
Property class
10.9
12.9
T40
Prescribed
tightening torque
(NVm)
67
67
115
135
220
340
A2463 5.0 en/de