Lengthening The Line - Toro 51452 Bedienungsanleitung

Starting and Stopping the
Trimmer
To start the trimmer, squeeze the trigger (Figure 5).
Figure 5
To stop the trimmer, release the trigger.
Trimming
Figure 6
Edging
Figure 7

Lengthening the Line

To increase the length of the cutting line, tap the spool on the
ground while the trimmer is running (Figure 8).
Note: The blade under the guard will cut the line to the correct
length.
Figure 8
Important: Use the following precautions to ensure
optimal line performance:
•
Do not hold the spool on the ground.
•
To help prevent line tangle, tap only once to lengthen line. If
additional line is required, wait a few seconds before tapping
the trimmer head.
•
If the line is not advanced occasionally, it will wear down
to the eyelet. When the trimmer stops, the short line may
retract into the cutter head. Should this occur, remove
spool, refeed the line through eyelet, and assemble spool to
trimmer.
Adjusting the Maximum Line
Length
You can change the maximum length of the cutting line to either
cut just inside the metal wire guide (for trimming next to plants
and structures that would be damaged by the line) or to extend
past the guide at the full cutting swath (for general trimming and
edging).
The blade under the guard is sharp and can cut you. Be
careful when handling the trimmer so that you do not
accidentally cut yourself.
To shorten the line to cut inside the wire guide, slide the lever on
the guard to the left (Figure 9).
Figure 9
To lengthen the line to cut outside the wire guide at the full
cutting swath, slide the lever on the guard to the right (Figure 10).
4