Medisana 86202 Gebrauchsanweisung Seite 37

PROG 3
This program should be used especially for muscle stimulation. It takes 30
minutes. The program consists of two loops of kneading pulses that are passed
through during the whole therapy time. (Details see table 3).
Number
Loop 1 (x 3)
1
2
3
4
5
6
Loop 2 (x 2)
7
8
9
10
11
12
13
14
Pulse Shape: Monophasic rectangular
with the set pulse width of 250 µs
Program 3 is a combination of 2 loops. The program starts with Loop 1 (number
1 - 6), which is repeated 3 times, lasting for 180 seconds.
After that, Loop 2 (number 7 - 14) is started. It is repeated twice, lasting for
176 seconds.
After Loop 2 is repeated twice, Loop 1 starts again. This process continues on
for 30 minutes.
You cannot change frequency, current selection and pulse width while the
program is running. However, the intensity is adjustable, and you should
correct the intensity, if you feel the treatment too intense or too low (especially
after alternation of the flows while the program is running, an adjustment of
the intensity to your feeling is recommended.
NOTE: PROG 1-3
Each of these programs starts (the set time of 30 minutes
starts running), as soon as you have selected it with the key K,
whether you have activated the intensity or not. Current
pulses are only send, when you increase the intensity. To
stop the program, switch off the MEDISANA TDD (key F).
Pulse Width (µs)
200 => 2
Stop
200 => 2
Stop
200 => 2
Stop
60 x 3 = 180
20
Stop
40
Stop
60
Stop
80
Stop
88 x 2 = 176
GB
3 Operating
Duration (min)
15
5
15
5
15
5
15
7
15
7
15
7
15
7
33