Troubleshooting; Cleaning And Maintenance - Power Craft 69370 Gebrauchsanweisung

Troubleshooting

Problem
Air leaking from top of air
nailer or around trigger.
Air leaking from bottom of air
nailer or between air nailer and
cylinder head.
Nails driven in too deep.
Air nailer is not working
properly or is not driving in
nails properly.
Air nailer skips nails
The nails get stuck in the
magazine.

Cleaning and maintenance

Clean the tool with a slightly damp cloth
after use and always keep all surfaces clean.
Make sure that the safety button is is free of
dirt and foreign matter.
If the compressed air supply does not mix
lubricating oil in the air, lubricate the tool
with oil via its compressed air nozzle every
1-2 hours of operation.
Cause
Trigger valve is damaged.
1. There are loose screws.
2. O-rings are worn or
damaged.
1. There are loose screws.
2. Supply pressure is too high.
1. Supply pressure too low
2. Air nailer needs lubrication
3. O-rings or gaskets are
damaged or air nailer is
defective.
1. Spring in magazine is
defective.
2. Front plate or magazine is
defective or dirty.
3. O-ring in piston is defective
or in need of lubrication.
4. Air nailer is defective
1. The wrong nails are in use,
or the staples are inserted
backwards.
2. The magazine is loose or
dirty.
3. Air nailer is defective
Apply a couple of drops of oil to the nozzle,
connect the tool to the hose and let the
tool run for a few seconds to lubricate it.
Lubricate the tool with 4-5 drops of oil using
the same method after use.
Check regularly to make sure that all parts
of the tool (gaskets, magazine, trigger, etc.)
are in good condition, and replace them if
not.
Solution
Have air nailer inspected and
repaired.
1. Tighten screws.
2. Have air nailer inspected and
repaired.
1. Tighten screws.
2. Reduce supply pressure.
1. Increase supply pressure.
2. Lubricate air nailer
3. Have air nailer inspected and
repaired.
1. Replace spring.
2. Clean front plate or
magazine.
3. Lubricate air nailer
4. Have air nailer inspected and
repaired.
1. Use the correct nails, or
insert nails correctly.
2. Mount the magazine
correctly and make sure that it
is clean.
3. Have air nailer inspected and
repaired.
DK
NO
SE
FI
GB
DE
PL
ET
29