Mini Tray - bloom Fresco contemporary Handbuch

Adjusting the shoulder straps height:
As your child grows you will need to alter the
height of the shoulder straps. The time to do this
is when the child's shoulders are above the slits
on the seat pad, where the shoulder straps pass
through.
NOTE: Every time you place your child in the
baby chair or whenever you alter the position
of the seat always check that the harness is
correctly fitted. Tighten the harness until it fits
snugly around your child.
c6 Mini Tray Assembly
– (#03 mini tray) Latch the hook located on the
bottom of the mini tray onto the safety bar
whilst rotating the tray downwards.
– Lock the mini tray into position by pressing
down on the left and right arm of the tray. The
pegs should snap into the holes on the tray.
You will hear an audible click.
– To remove the mini tray, reverse the order of
assembly steps.
– The mini tray is dishwasher safe, and is made
of FDA compliant food contact grade plastic.
c7 Food Tray Assembly
– (#04 food tray) Squeeze the left and
right trigger located under food tray
simultaneously, whilst sliding the food tray
onto the mini tray, then release triggers at
your desired setting. You will hear an audible
click. Check the food tray is locked in place by
attempting to pull it free of the highchair.
– The food tray can be locked in two positions.
– To adjust the tray, pull the left and right side
triggers located under the tray simultaneously
whilst sliding the tray forwards or backwards.
Release triggers at the desired setting. You
will hear an audible click. Check the food tray
is locked in place by attempting to pull it free
of the highchair.
– To remove the food tray, reverse the order of
assembly steps.
– The food tray is dishwasher safe, and is made
of FDA compliant food contact grade plastic
and stainless steel.
NOTE: Always check the tray is securely locked
in place by attempting to pull it free of the
highchair.
c8 -c10 Seat Unit Height and Seat Unit Recline
– To adjust seat height, disengage the
swivel/height resistor. Lift both A & B trigger
simultaneously, whilst pushing downwards
or pulling upwards to desired height, then
release the triggers.
– To adjust the seat unit between the upright
position to the first recline position, depress
the handle on the rear of the seat unit
upwards whilst rotating the seat upwards
or downwards to the desired position, then
release the handle. You will hear an audible
click. Check the seat unit is locked in position
by moving it.
– The food tray, mini tray, and safety bar can be
applied on the highchair for the upright and
first recline position.
eng
7