Viewing The Log File; Viewing Parameters; Maintenance - Abus eyseo TV7230 Installationsanleitung

Viewing the log file

Click this link on the configuration page to display the system log file. The contents of the file supply
useful information about the configuration and the connection following a system start. The standard of
the log file is RFC 3164. You can also send data to a log server. Enable "Remote Protocol" and enter
the IP address and the port number of the server.

Viewing parameters

Click this link on the configuration page to display all system parameter sets. The contents correspond
to those of CONFIG.INI.

Maintenance

Reboot system
Click to reboot the system.
Factory default
Click to restore the factory settings. All previous settings are discarded.
Calibrate
Recalibrate the home position to the default center to recover the tolerance cased by some external
forces. This function is the same as the "Center" button on the Remote Controller. Please note that
there is no confirming message box after clicking on the "Calibrate" button, the network camera will
calibrate immediately.
Upgrade firmware
Like an update with the installation wizard, you can update the firmware of the network camera here.
You can download the latest firmware from www.abus.sc.com. Select the update file (flash.bin) and
click "Upgrade". The update takes a short time. When you restart the camera, it is started with the new
firmware.
35