Risk Of Injury From Pressurised Components; Risk Of Burns Due To An Uncontrolled Escape Of Hot Fluids; Risk Of Burns Due To Hot Components And Surfaces; Risk Of Injury In Case Of Improper Work - oventrop 1124550 Betriebsanleitung

Dirt separator
2.4.3 Risk of injury from pressurised
components
 Before starting work on the heating circuit, make
sure that the system has been depressurised.
 Observe the permissible operating temperatures
during operation.
2.4.4 Risk of burns due to an uncontrolled
escape of hot fl uids
 Only carry out work when the system is depressuri-
sed.
 Before starting work, let the product cool down.
 Check that the product is not leaking after work is
complete.
 Wear protective clothing.
2.4.5 Risk of burns due to hot components and
surfaces
 Allow the product to cool down before working on it.
 Wear protective clothing to avoid unprotected cont-
act with hot system components.
2.4.6

Risk of injury in case of improper work

Stored residual energies, angular components points
and edges at the outside and inside of the product
may cause injuries.
 Before starting work, make sure that there is enough
space.
 Handle open and hard-edged components with
care.
 Make sure that the work place is tidy and clean to
avoid accidents.
2.4.7

Risk of injury from heavy dirt separator!

 Wear safety shoes during installation.
 If necessary, ask other persons for help during ins-
tallation.
 If necessary, use carrying equipment.
2.4.8 Damage to property due to an unsuitable
installation location
 Do not install the product at locations prone to frost.
 Do not install the product at locations with corrosi-
on-enhancing ambient air.
2.4.9

Availability of the operating instructions

These operating instructions and all other relevant
documents (e.g. operating instructions of accesso-
ries) must be read and applied by any person wor-
king on the product.
The operating instructions must be available at the
installation location.
 Hand these operating instructions and all other
relevant documents (e.g. accessory manuals) over to
the user.
112455080-V02.09.2019
3.

Technical description

3.1

Design

Illust. 2: Design
(1) Flange connection
(2) Drain valve
(3)
Magnet
From DN 125 there are eyelets for attachment
to the dirt separator.
Illust. 3: Design
(1) Eyelets
Technical description
1
2
3
1
15