GRAPHITE 59G824 Betriebsanleitung Seite 30

Always fix processed material in place to guarantee optimal work safety.
Do not cut objects too small to fix in place.
CHECKING AND ADJUSTMENT OF CUTTING DEPTH
Before starting to work it is necessary to check maximal cutting depth, to make sure the cutting
blade will not touch flip over saw base.
● Set the turntable (34) and the saw arm to 0
●
Change position of the limiter (
●
Lower the saw arm and hold it in this position, pressed against the stopping fender.
●
Turn the cutting blade (
●
Proper adjustment of full cutting depth should allow cutting blade (
upper surface of the turntable (34) (fig. P).
●
In case the setting is wrong, turn the adjustment screw (
cutting blade penetration depth is appropriate.
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the rating plate of the saw.
Switch on the saw only when cutting blade is away from the material that is to be cut.
The mitre saw features switch lock button (43) that protects against accidental starting.
Switching on
●
Press the switch lock button (
●
Press and hold the switch button (
Switching off
●
Release pressure on the switch button (
In the mitre saw mode the switch (8) is deactivated.
CUTTING OFF NARROW PIECES OF MATERIAL
Cutting off is used mostly for narrow pieces of material. Prior starting to cut ensure that the table rotation
locking knob (32) and the locking lever for cutting blade tilt (6) are firmly tightened.
● Fix the material to the worktable, consider its size.
●
Set desired cutting angle.
●
Unlock the saw arm and the cutting blade shield.
●
Press the switch button (
●
Hold the handle grip (
●
Switch off the saw and wait until the cutting blade stops completely.
●
Slowly lift the saw arm.
Insufficient tightening of the table rotation locking knob may cause unexpected move of cutting
blade to upper surface of the material. It puts operator in danger of being hit with piece of
material.
SETTING THE WORK TABLE FOR MITRE CUTTING
The turntable (34) allows cutting material at any angle within range of 45
position.
● Pull and turn the head locking pin (31) and allow the saw arm to lift slowly to upper position.
●
Loosen the table rotation locking knob (
●
Set the turntable ( 34) at desired angle accordingly to the angle scale of turntable (35) (fig. S).
●
Lock by tightening the table rotation locking knob (
There are many grooves in the turntable (34) that are used to easily pick frequently used angles. Those are
cutting angles that are used most often (0
with the use of the angle scale of turntable (35) scaled every degree. Even though the scale is accurate
enough for most of performed tasks, it is recommended to double check the cutting angle with protractor
or other device for angle measurements.
0 position.
50) so it can rest on the adjustment screw (a) (fig. N).
14) by hand to make sure it is free to move.
43).
45) (fig. R).
45).
8) (wait until cutting blade reaches its top rotational speed).
44) and bring it down slowly. Make a cut by applying moderate pressure.
32).
0 , 15 0 , 22.5
14) to penetrate 5 mm below the
a) (fig. N) clockwise or counter-clockwise until
0 left or right from the perpendicular
32).
0 , 30 0 , 45 0 left or right). Any angle can be set precisely
30