Timer - Mitsubishi Electric PLFY-P VFM-E1-Serie Bedienungshandbuch

Seasonal airflow
Seasonal airflow
Cooling/Heating
Select:
F1 F2 F3 F4
Notes:
Any person at the following places cannot be detected.
the air conditioner
A person may not be detected in the following situations.
present.
to measure the floor temperature and detect persons in the room.
the i-See sensor is moving.
units, No occupancy Auto-OFF cannot be used.

4. Timer

Timer functions are different by each remote controller.
For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.
1 Select the setting with the [F4]
button.
OFF Cooling only Heating
only Cooling/Heating OFF
After changing the setting, press
the [SELECT] button to save the
setting.
OFF: The function is disabled.
Cooling only: When the thermostat
turns off during cooling mode, the
vanes move up and down.
Heating only: When the thermostat
turns off during heating mode,
the vanes move to the horizontal
airflow direction to circulate the air.
Cooling/Heating: The function is
enabled during both cooling mode
and heating mode.
* In order to enable this function,
the airflow direction must be set
to "Auto".
Notes:
During swing operation, the directional indication on the screen
does not change in sync with the directional vanes on the unit.
Available directions depend on the type of unit connected.
In the following cases, the actual air direction will differ from the
direction indicated on the remote controller display.
2. Immediately after starting heat mode (while the system is wait-
ing for the mode change to take effect).
perature setting.
For LOSSNAY combination
The following 2 patterns of operation is available.
• Run the ventilator together with indoor unit.
• Run the ventilator independently.
Notes: (for wireless remote controller)
Running the ventilator independently is not available.
No indication on the remote controller.
-