Connecting The Speakers - Onkyo HTP-528 Bedienungsanleitung

Connecting the Speakers

Read the following before connecting your speakers:
• Turn off your receiver before making any connections.
• Pay close attention to speaker
wiring polarity. Connect positive
(+) terminals to only positive (+)
terminals, and negative (–)
terminals to only negative (–)
terminals. If the speakers are
wired incorrectly, the sound will
be out of phase and will sound unnatural.
• Be careful not to short the positive and negative wires.
Doing so may damage your amp.
Subwoofer
* Using the supplied RCA cable, connect the subwoofer's LINE INPUT to your AV receiver's SUBWOOFER PRE
OUT.
6
En-
Front Right Front Left
Red White
Connecting the Speaker Cables
Use the supplied cables to connect each
speaker's input terminals to the corresponding
speaker output terminals on your receiver.
Match the color of each cable to the corresponding
speaker terminal.
To make a connection, while pressing the
terminal lever, insert the wire into the
hole, and then release the lever. Make
sure that the terminals are gripping the
bare wires, not the insulation.
Surround
Right
Gray Green
Surround
Left
Center
Blue