Relative air humidity
Ambient temperature for operation
Storage temperature
WiFi frequency, channels 1-11
WiFi frequency, channels 36-48
Maximum emitted transmission power,
channels 1-11
Maximum emitted transmission power,
channels 36-48
4.2
Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5
Before use
5.1
Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2
Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.3
Switching on the scanning tool
1. Press the
button.
2. The 'Accept disclaimer' message appears on the display. You must accept the terms of this notice
shown in order to operate the scanning tool.
Outside the operating temperature range, a fault message is displayed and the scanning tool
automatically switches off. Allow the scanning tool to cool down or warm up, as appropriate, and
then switch it on again.
5.4
Starting for the first time
1. Insert the battery. → page 18
2. Switch on the scanning tool. → page 18
18
English
Printed: 09.05.2019 | Doc-Nr: PUB / 5493111 / 000 / 00
PS 300
90 %
−10 ℃ ... 50 ℃
(14 ℉ ... 122 ℉)
−25 ℃ ... 63 ℃
(−13 ℉ ... 145 ℉)
•/•
•/•
•/•
•/•
2200189
PS 300-W
90 %
−10 ℃ ... 50 ℃
(14 ℉ ... 122 ℉)
−25 ℃ ... 63 ℃
(−13 ℉ ... 145 ℉)
2,412 MHz ... 2,462 MHz
5,180 MHz ... 5,240 MHz
100 mW
50 mW
10.8 V
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
*2200189*