Preparation For Operation - GRAPHITE 58G119 Betriebsanleitung

Use the powertool according to the manufacturer's instructions only.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. Quick-release chuck
2. Torque control ring
3. Direction selector switch
4. Battery lock button
5. Battery
6. Switch
7. Gear switch
* Slight differences may appear between the product and drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Battery - 2 pcs
2. Charger - 1 pce
3. Charging station - 1 pce
4. Drills - 6 pcs
5. Driver bits - 8 pcs
6. Bit holder - 1 pce
REMOVING AND INSERTING THE BATTERY
● Set the direction selector switch (3) in middle position
● Push buttons ( 4) and slide the battery (5) to the front (fig. A).
● Insert charged battery ( 5) into the handle holder, you should hear when the lock buttons (4) snap.
CHARGING THE BATTERY
Drill is supplied with partially charged battery. Charge the battery full before use. Charging the battery should be carried out
in temperature between 4°C to 40°C. New battery, or one that have not been used for a long time, will reach full efficiency
after approximately 5 charge/discharge cycles.
● The mains voltage must match the voltage on the charger rating plate.
● Always check technical condition of the charger, charging station and power cord before starting to charge.
● When charging the battery, use only the charger and the charging station supplied with the drill.
● Do not expose the charger and charging station to rain or splashing.
● Set the direction selector switch (3) in middle position.
● Remove the battery ( 5) from the drill (fig. A).
● Insert the battery ( 5) into the socket of the charging station (10) (fig. B).
● Connect charger power cord to the socket of the charging station.
● Connect the charger to mains socket (230V).

PREPARATION FOR OPERATION

14