Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTRUCTIONS FOR USE
Remove stones, loose pieces
of wood and other objects
from the cutting area.
The cutting line continues to rotate for a few
seconds after the trimmer is switched off.
Allow the motor/cutting line to stop rotating
before switching "on" again.
Do not rapidly switch off and on.
_
Connect the appliance to a suitable extension
cord.
_
Hook the extension cord behind the clamp.
_
Hold the appliance with both hands.
_
Slowly move the appliance back and forth.
_
When working long grass proceed layer
for layer.
_
Keep the appliance away from hard
objects and plants.
_
Only use the appliance for working dry
grass.
_
When edging, guide the appliance over
the edge guide along the grass edge.
_
The appliance will automatically feed the
cutting line during use.
SWITCHING ON AND OFF
_
To switch the appliance on, press the
on/off switch (1).
_
To switch the appliance off, release the
on/off switch (1).
CLEANING AND MAINTENANCE
maintenance to the machine,
always unplug the machine.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
The machine does not require any special
maintenance.
_
Regularly clean the ventilation slots.
_
Regularly clean the cutting line and the spool.
_
Regularly remove grass and dirt from the
guard.
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-
sales service department.
_ If the connecting cable (or mains plug) is
damaged, it must be replaced by a particular
connecting cable which is available from our service
department. Replacement of the
connecting cable must only be carried out by our
service department (see last page) or by
Before performing
a qualified person (qualified electrician).
Warning! Before performing any maintenance on
corded/cordless power tools:
u Switch off and unplug the appliance/tool.
u Or switch off and remove the battery from the
appliance/tool if the appliance/tool has a separate
battery pack.
u Or run the battery down completely if it is integral
and then switch off.
u Unplug the charger before cleaning it. Your
charger does not require any maintenance apart
from regular cleaning.
u Regularly clean the ventilation slots in your
tool/appliance and charger using a soft brush or
dry cloth.
u Regularly clean the motor housing using a damp
cloth. Do not use any abrasive or solvent-based
cleaner.
u Regularly clean the cutting line and spool using a
soft brush or dry cloth.
u Regularly use a blunt scraper to remove grass
and dirt from the underneath of the guard.
TECHNICAL DATA
Mains voltage V
Mains frequency Hz
Power input W
-1
No load speed min
Max. cutting circle mm
Weight kg
Acoustic pressure level
LpA 84.5 dB(A) K = 3dB(A)
Acoustic power level
LwA 94.1 dB(A) K = 1.94 dB(A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. : = 15.213 m/s² , uncertainty
(K) = 1.5 m/s².
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
230
50
500
10000
300
2.8
ATTENTION !
must be worn.
20
Werbung
Inhaltsverzeichnis
