Kd-49Xg81 / 49Xg80 / 43Xg81 / 43Xg80 - Sony SU-WL450 Installationsinformationen

2
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV
is installed.
Refer to the Reference Guide supplied with
your TV.
Note
 Subcontract the cable routing in the wall to a licensed
contractor.
 Bundle the connecting cables to prevent stepping on
them before wall mounting.
3
Detach the Table-Top Stand
from the TV.
Note
 Be careful when lifting the TV as the Table-Top Stand
is detached, the Table-Top Stand may topple over
and cause personal injury.
 Take care when removing the Table-Top Stand from
the TV to prevent it from falling over and damaging
the surface that the TV is sitting on.
KD-49XG81 /
49XG80 / 43XG81 /
43XG80
1
Detach the Table-Top Stand
from the TV.
Note
 Make sure to place TV on the place where you put a
soft cloth on to prevent damaging display's surface.
 When installing the Wall-Mount Bracket, do not use
the screws removed from the Table-Top Stand.
 Be sure to store the removed Table-top Stand and its
screws in a safe place, keeping them away from
children. You will need them if you want to use the TV
on a table in the future. The Table-Top Stand cannot
be purchased separately.
WARNING
 Be sure the TV is on the vertical position before
switching on. TV set must not powered on with LCD
panel face down to avoid uneven picture uniformity.
 If pressure or shock is applied to the surface of the
TV, the TV may break or become damaged.
 Lay the TV face down on a stable and level surface
with the Table-Top Stand hanging over the edge of
the surface. Having the TV face and the base of the
Table-Top Stand on the same level surface will create
an unstable working condition and can damage the
TV.
 When detaching the Table-Top Stand from the TV,
hold the Table-Top Stand securely with both hands.
2
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
5.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
 Be sure to store the used or unused parts in a safe
place for future use. Retain this manual for future
reference.
Standard mounting (2-a)
Screw
(+PSW 6 x 20) 
Pulley 
Soft cloth
− 12 (GB) −
Screw
(+PSW 6 x 50) 
Spacer
(60 mm) 
Belt 