Safety Instructions - Lukas AMIN 20-030 GH Bedienungsanleitung

disconnected from the compressed air supply.
After a tool change, the power tool must be test run in a safe place (e.g., underneath
the work bench) with the tool clamped in position.

5. Safety Instructions

Due to the large number of available shaft diameters, there is a risk of confusion
thereby mismatching tool shaft and collet diameter.
The power tool must not be operated with damaged or incorrectly clamped tools as
this may cause vibration.
When machining certain materials, dust and vapour may occur which result in an
explosive atmosphere. The power tool must not be used in an explosive atmosphere.
After switching off, the power tool may continue to run for a few seconds. The tool
must not be touched until it is at a standstill.
In the case of failure of the compressed air supply, the power tool must be switched
off at the valve so as to prevent uncontrolled start-up when the pressure returns.
Compressed air hoses may whip uncontrollably and may cause serious injury.
Energy retained in the form of compressed air bears a potential safety risk.
A maximum air pressure of 0,63 MPar must not be exceeded during power tool
operation. The power tool must only be connected using a pressure control valve.
Make sure that loose clothing and long hair are not ensnared by the power tool when
in operation.
To protect the operator, he or she must wear goggles and ear protection during
operation. It is recommended that gloves and suitable protective clothing is worn.
Depending on the materials to be machined, personal protection equipment and dust
Stand: 25.01.2013 15 - AMIN 20-030 GH -