Switching The Engine Off - Hilti DSH 600 Bedienungsanleitung

6.2 Checks after starting the engine
1. Check that the cutting disc remains stationary when the engine is idling and, after briefly running at full
speed, that the disc again comes to a complete standstill.
◁ Readjust (reduce) the idling speed if the cutting disc doesn't stop rotating when the engine is idling.
If this is not possible, please bring the product to Hilti Service.
2. Check that the start/stop switch is functioning correctly. Move the start/stop switch to the "stop" position.
3. If the following equipment exists, also take this action:
DSH 600
▶ If the engine doesn't stop, push the choke lever upwards. If the engine still doesn't stop, pull the
spark plug connector off the spark plug and bring the product to Hilti Service.
4. If the following equipment exists, also take this action:
DSH 600-X
▶ If the engine doesn't stop, compress the primer bulb. If the engine still doesn't stop, pull the spark
plug connector off the spark plug and bring the product to Hilti Service.
6.3

Switching the engine off

WARNING
Risk of injury. A rotating cutting disc can break or shatter, possibly resulting in flying fragments.
▶ Allow the rotating cutting disc to come to a complete standstill before you lay the saw down.
1. Release the throttle trigger.
2. Move the start/stop switch to the "stop" position.
◁ The engine stops.
6.4 Cutting techniques 9,
WARNING!
In order to work optimally with this tool, the following safety instructions must be observed:
▶ Always hold the tool with both hands on the grips provided. Keep the grips dry, clean and free from oil
and grease.
▶ Before beginning the work, or if the disc has inadvertently come into contact with an obstacle (e.g. a
concealed object), check the cutting disc and guard immediately for possible damage.
▶ Check that no persons are present in the working area and, in particular, in the direction in which the cut
is to be made. Keep other persons approx. 15 m away from your workplace.
▶ Guide the tool smoothly and do not apply lateral pressure to the cutting disc.
▶ Avoid hazardous operating positions.
▶ Always bring the cutting disc into contact with the workpiece at right angles. Do not attempt to alter the
line of cut by applying lateral pressure or by bending the cutting disc while cutting is in progress.
▶ Secure the workpiece. Use clamps or a vice to hold the workpiece in position. The workpiece is thus
held more securely than by hand and both hands remain free to operate the tool.
▶ Clamp round workpieces so that they cannot rotate.
▶ Do not cut several workpieces at the same time. Cut them one after the other.
▶ Secure the workpiece and the part to be cut off in order to prevent uncontrolled movement.
▶ Always apply full throttle when cutting.
Avoiding sticking / stalling of the cutting disc
WARNING
Risk of bruising or other injuries. Sticking / stalling of the cutting disc in the kerf may cause the saw to be
pulled forward, to climb or cause kickback.
▶ Take care to avoid sticking / stalling of the cutting disc while cutting.
Reasons for the cutting disc sticking / stalling:
• The cut is too deep.
• The kerf becomes narrower (e.g. when cutting pipes or slabs).
• The cutting disc is tilted.
• An unsuitable cutting disc is used (the cutting disc becomes clogged).
• The cutting disc is inserted too quickly in an existing kerf.
2136486
*2136486*
Printed: 11.06.2018 | Doc-Nr: PUB / 5341995 / 000 / 03
10
English 33