Care And Maintenance - Denver Instrument Timberline TP-214 Betriebsanleitung

Care and Maintenance

24
Service
Regular servicing by a trained DENVER dealer
will extend the service life of your balance and
ensure its continued weighing accuracy. DENVER
can offer you service contracts, with your choice
of regular maintenance intervals. The optimum
maintenance interval depends on the operating
conditions at the place of installation and on the
individual tolerance requirements.
Repairs
Repair work must be performed by trained service
technicians. Any attempt by untrained persons to
perform repairs may lead to hazards for the user.
Cleaning
§ Unplug the AC adapter from the wall outlet
(mains supply). If you have an interface cable
connected to the balance port, unplug it from
the port,
§ Clean the balance using a piece of cloth which
has been wet with a mild detergent (soap)
§ After cleaning, wipe down the balance with
a soft, dry cloth.
Removing and Cleaning the Weighing Pan:
§ Lift up and remove the weighing pan together
with the pan support by gripping them from
under the shield ring. Make sure that you do
not damage the weighing system in doing so.
!Make sure that no liquid enters the balance
housing.
!Do not use any aggressive cleaning agents
(solvents or similar agents).
Cleaning Stainless Steel Surfaces
Clean all stainless steel parts regularly. Remove
the stainless steel weighing pan and thoroughly
clean it separately. Use a damp cloth or sponge to
clean any stainless steel parts on the balance. Only
use commercially available household cleaning
agent that is suitable for use on stainless steel.
Clean stainless steel surfaces by wiping them
down. Then rinse thoroughly, making sure to
remove all residues. Afterwards, allow the balance
to dry. If desired, you can apply oil to the cleaned
surfaces as additional protection. Solvents are
permitted for use only on stainless steel parts.