Proper Use; Technical Data - Parkside PDKS 120 A2 Bedienungs- Und Sicherheitshinweise

Anleitung_LB7_4309028:_
GB/
CY

5. Proper use

The fretsaw was designed to cut square-edged
timber or wood-like workpieces such as
Plexiglas, glass fiber reinforced plastic, foam,
rubber, leather, and cork. Do not use this saw to
cut round materials. Round materials can easily
become jammed. Risk of injury! Parts can be
catapulted!
The equipment may only be used for the tasks it
is designed to handle. Any other use is deemed
to be a case of misuse. The user/operator and
not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the equipment is used in commercial,
trade or industrial businesses or for equivalent
purposes.
The equipment is to be operated only with
■
suitable saw blades. It is prohibited to use
any type of cutting-off wheel.
To use the equipment properly you must
■
also observe the safety information, the
assembly instructions and the operating
instructions to be found in this manual.
All persons who use and service the
■
equipment have to be acquainted with these
operating instructions and must be informed
about the equipment's potential hazards.
It is also imperative to observe the accident
■
prevention regulations in force in your area.
The same applies for the general rules of
■
health and safety at work.
The manufacturer will not be liable for any
■
changes made to the equipment nor for any
damage resulting from such changes.
Residual risks
Even if you use this electric power tool in
accordance to instructions, certain residual
risks cannot be eliminated. The following
hazards may arise in connection with the
equipment's construction and layout:
12
25.05.2011 14:08 Uhr Seite 12
Lung damage if no suitable protective dust
■
mask is applied
Damage to hearing if no suitable ear
■
protection is applied
Contact with the blade in the uncovered
■
cutting zone
Injuries (cuts) when changing the blade
■
Crushed fingers
■
Kickback
■
Tilting of the workpiece due to inadequate
■
support
Touching the blade
■
Catapulting of pieces of timber and
■
workpieces

6. Technical data

Mains voltage:
Power input:
Operating mode:
Power input:
Operating mode:
Idle speed n
Protection type:
Stroke:
Base area:
Tilting range of table:
Table size:
Length of saw blade:
Reach:
Max. cutting height at 90°:
Max. cutting height at 45°:
Weight:
Operating mode S6 30%:
Continuous operation with idling (cycle time 10
minutes). To ensure that the motor does not
become excessively hot, it may only be
operated for 30% of the cycle at the specified
rating and must then be allowed to idle for 70%
of the cycle.
230 V ~ 50 Hz
S6 30%
S2 20 min
: 400 - 1,600 rpm
0
21 mm
410 x 245 mm
0° to 45° to the left
410 x 253 mm
134 mm
406 mm
57 mm
32 mm
approx. 10.5 kg
120 W
80 W
IP 20