Operating Settings Configuration; Home Screen; Test Mode; Auto Test - Chauvet Professional Maverick MK2 Wash Schnellanleitung

Operating Settings Configuration

Home Screen

The Maverick MK2 Wash has a home screen that shows the current control protocols, personalities,
starting addresses, IP addresses, and universes. To see the home screen, press <MENU> repeatedly until
it shows on the display. From the home screen, touch any of the displayed control settings to immediately
jump to that part of the menu (e.g., the personality, starting address, or universe) or press <ENTER> to
reach the main menu.

Test Mode

Auto Test

To perform an auto test of the Maverick MK2 Wash functions, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Test Mode, or touch the display where it
says Test Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select Auto test, or touch the display where it says Auto test.
5. Press <ENTER>.

Manual Test

To test the functions of the product manually, do the following:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Test Mode, or touch the display where it
says Test Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select Manual Test, or touch the display where it says Manual Test.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Use <UP> or <DOWN> to select the function to test, or touch the display where it says the desired
function.
7. If using the buttons instead of the touchscreen, press <ENTER>.
8. Change the value of the tested function with one of the following methods:
• Type the desired value using the number pad that shows on the touchscreen display.
• Use <UP>, <RIGHT>, <DOWN>, or <LEFT> to increase or decrease the value.
9. Press <ENTER>.

Setup

To reach the Setup menu, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Setup, or touch the display where it says
Setup.
3. If using the buttons instead of the touchscreen, press <ENTER>.

Network Settings

To reach the Network Settings menu, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Network Settings, or touch the display where it says Network
Settings.
3. If using the buttons instead of the touchscreen, press <ENTER>.
Page 41 of 275
Home Screen
Home Screen
Home Screen
menu.
shows on the display. Press <ENTER>.
shows on the display. Press <ENTER>.
shows on the display. Press <ENTER>.
Maverick MK2 Wash User Manual Rev. 10
Operation