Schneider Airsystems AirMaster AM 22-8 Original Bedienungsanleitung Seite 44

24 OIL RECOMMENDIATION FOR GARDNER DENVER SCREW
INDUSTRIAL COMPRESSORS
24.1 Recommended lubricant
Schneider Druckluft GmbH compressors have been tested and authorized to be used only with OEMIN-
Schraub lubricants. These lubricants are formulated according to the highest quality standards and are
factory authorized, tested and approved for use in rotary screw compressors. OEMIN-Schraub, OETSYN-
Schraub lubricants are available from your authorized Schneider Druckluft GmbH compressor distributor.
24.2 Oil specifications
The recommended compressor lubricants are:
- OEMIN-Schraub. Factory first fill.
- OETSYN-Schraub
Package size
1 Liter
5 Liter
* first fill
** for low external temperature
24.3 General guidelines for oil change intervals (see controller manual for more
details)
The recommended oil change intervals are:
Compressor
temperature
Specific OEMIN-Schraub, OETSYN-Schraub lubricants are recommended for use in this
equipment. Other lubricants may cause :
-
shorter life span of oil filters, oil separators and oil
-
varnishing and blockage of oil circuit
-
higher oil consumption
-
excessive carryover and compressor damage
Do not mix different types of oil.
Please Note! If a wrong oil type has been used or the oil circuit is varnished contact Schneider Druckluft
GmbH specialists for oil circuit cleaning instructions.
OEMIN-Schraub *
order number
OEMIN-Schraub
change interval
70 – 88°C
88 – 92°C
≥ 93°C
-
B111010
OETSYN-Schraub
change interval
3.000 h
1.000 h
500 h
2-20
OETSYN-Schraub
order number
B111013
B111012
4.000 h
2.000 h
1.000 h