HAIRCUT TH35 Benutzerhandbuch Seite 24

PROFESSIONAL CORDLESS HAIR CLIPPERS
During their assembly, the upper and lower cutters must be aligned as instructed
below:
 Set the adjusting lever to the minimum cutting height.
 The distance between the front edge of the lower cutter and the front edge of
the upper cutter must be between 0.8 mm and 1.5 mm.
 The upper and lower cutters must be set parallel.
 The end tooth on the upper cutter (on the left-hand end) must cover the end
tooth on the lower cutter.
 The other end tooth on the upper cutter (on the right-hand end) must also
touch the corresponding end tooth on the lower cutter (on the right-hand end).
 Tighten the two screws (Fig. 4).
4. Servicing
4.1. Routine servicing
 After 30 minutes of use, it is advisable to lubricate the blades. Use the
lubricating oil supplied with the clippers (Fig. 1-M).
 Lubricate the blades at least once a day (Fig. 5).
 After using the clippers each time, clean the blades with the brush supplied
(Fig. 1-N).
 If necessary, clean the body of the clippers with a cloth slightly moistened with
water or mild liquid soap. Never use abrasive products or solvents.
 Clean the blades with an antibacterial spray. We recommend the STERIL
CLEANER 920- cleaning, lubricating and disinfecting product.
4.2. Cleaning the blades
In the case of intensive use, clean the blades at least once a day.
 Remove the blades as described in § 3.5.
 Clean the inside of the blades with the brush supplied (Fig. 1-N).
 Lubricate the cutters (Fig. 5) and put the blades back on the clippers as
described in § 3.5.
24
EN