Charging Process; Spare Parts And Accessories - Flex DD 2G 10.8-LD Originalbetriebsanleitung

DD 2G 10.8-LD
Displays of LED
red green
off flashes Battery is charging.
Charging process finished.
off on
Maintenance charging.
See "Charging process".
flashes off Battery is too hot or too cold.
on off Battery or charger is faulty.
See "Fault messages".

Charging process

CAUTION!
Insert only original batteries in the supplied charger.
 Insert the charger mains plug.
The LED fault message and the LED charge status light
up for a short time.
 Insert battery into the charger as far as stop (Figure M).
The LED charge status flashes and the battery is
charged. When the battery is fully charged, the LED
charge status is lit continuously.
 Remove the battery from the charger (Figure N).
 Pull out the mains plug.
Fault messages
If the LED fault message lights up after the battery is inserted
into the charger, there is an fault with the battery or charger.
The LED warning message is lit up continuously:
– The battery is too hot or too cold. The charging process
starts when the battery reaches the charging
temperature (0°C...40°C).
The LED fault message flashes or none of the two LEDs
lights up:
– Remove battery from the charger. Check contacts at
charger and battery for contamination and clean if
necessary. Reinsert battery. The battery is faulty if the
same display appears again. Replace battery or have it
checked in a professional workshop.
– If this fault message is also displayed with a different
battery, then there is a fault with the charger. Have the
charger checked by a professional workshop.
Tips for a long battery service life
CAUTION!
– Never charge batteries at temperatures below 0 °C or
above 40 °C.
– Do not charge batteries in environments with high air
humidity or ambient temperature.
– Do not cover batteries and the charger during the
charging process.
– Pull out the charger mains plug at the end of the charging
process.
Battery and charger heat up during the charging process.
This is perfectly normal!
Lithium-ion batteries do not exhibit the established "memory
effect". Nevertheless, a battery should be completely
discharged before charging and the charging process should
always be fully completed.
If batteries are not used for an extended period of time, store
them partially charged in a cool place.
Maintenance and care
Cleaning
WARNING!
If metals are worked over a prolonged period,
electroconductive dust may become deposited inside
the housing.
Clean the power tool and ventilation slots at regular
intervals. Frequency of cleaning is dependent on
the material machined and the duration of use.
 Regularly blow out the housing interior and motor with
dry compressed air. Keep the power tool running while
doing this.
Charger
WARNING!
Before performing any work, pull out the mains plug. Do not
use water or liquid detergents.
 Remove dirt and dust from the housing with a brush or a
dry cloth.
Repairs
Repairs may be carried out by an authorised customer
service centre only.

Spare parts and accessories

For other accessories, in particular cutting accessories,
please refer to the manufacturer's catalogues.
Exploded drawings and sparepart lists can be found on our
homepage:
www.flex-tools.com
Transport
The lithium equivalent content of the batteries contained in the
scope of delivery is below the relevant limit values. Therefore
the battery as a separate component and the power tool with its
scope of delivery are not subject to national or international
dangerous goods regulations.
If several devices containing lithium-ion batteries are
transported, these regulations may become relevant and
require special safety measures (e.g. for the packaging).
In this case acquaint yourself with the regulations that apply to
the country of use.
15